[opensuse-factory] ./configure Permission Denied
Hey Group; Do I need to replace bash to solve the problem with every source not allowing ./configure to run. Try a source with a ./configure script and every one of them give a "Permission Denied". This is a RC2 problem never seen before from a SuSE version from way back 5 or 6. I must assume this is just any over site. Please fix it. Or is it necessary to look elsewhere for a Linux distribution lacking a defective bash, syslinux and/or fuse. bash version is "bash-4.0.19-5-i586", This is a very irritating problem. This complaint comes from "-bash:". as "-bash: ./configure Permission Denied" -- 73 de Donn Washburn 307 Savoy Street Email:" n5xwb@comcast.net " Sugar Land, TX 77478 LL# 1.281.242.3256 Ham Callsign N5XWB HAMs : " n5xwb@arrl.net " VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg BMW MOA #: 4146 - Ambassador " http://counter.li.org " #279316 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
On Mon, Nov 23, 2009 at 09:25:52PM -0600, Donn Washburn wrote:
Hey Group;
Do I need to replace bash to solve the problem with every source not allowing ./configure to run. Try a source with a ./configure script and every one of them give a "Permission Denied". This is a RC2 problem never seen before from a SuSE version from way back 5 or 6. I must assume this is just any over site. Please fix it.
Or is it necessary to look elsewhere for a Linux distribution lacking a defective bash, syslinux and/or fuse. bash version is "bash-4.0.19-5-i586",
This is a very irritating problem. This complaint comes from "-bash:". as "-bash: ./configure Permission Denied"
Well, is the configure script not marked executable? Or Is the filesystem perhaps marked as "noexec"? Ciao, Marcus -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
On 11/24/2009 04:53 AM, Marcus Meissner wrote:
On Mon, Nov 23, 2009 at 09:25:52PM -0600, Donn Washburn wrote:
Hey Group;
Do I need to replace bash to solve the problem with every source not allowing ./configure to run. Try a source with a ./configure script and every one of them give a "Permission Denied". This is a RC2 problem never seen before from a SuSE version from way back 5 or 6. I must assume this is just any over site. Please fix it.
Or is it necessary to look elsewhere for a Linux distribution lacking a defective bash, syslinux and/or fuse. bash version is "bash-4.0.19-5-i586",
This is a very irritating problem. This complaint comes from "-bash:". as "-bash: ./configure Permission Denied"
Well, is the configure script not marked executable? Or Is the filesystem perhaps marked as "noexec"?
Ciao, Marcus
No Sir! I even as a test set all of the files to 777 and it fails. Also here is a strace conf.err output. It is short You may have found it!!!! /etc/fstab shows sdc1 as clear of noexec but /etc/mtab shows it. Where does mtab get its information? -- 73 de Donn Washburn 307 Savoy Street Email:" n5xwb@comcast.net " Sugar Land, TX 77478 LL# 1.281.242.3256 Ham Callsign N5XWB HAMs : " n5xwb@arrl.net " VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg BMW MOA #: 4146 - Ambassador " http://counter.li.org " #279316
Hi, On Tue, Nov 24, Donn Washburn wrote:
No Sir! I even as a test set all of the files to 777 and it fails.
Also here is a strace conf.err output. It is short
You may have found it!!!!
/etc/fstab shows sdc1 as clear of noexec but /etc/mtab shows it. Where does mtab get its information?
Did you mount the partition as unprivileged user (option "user" in fstab)? "user" implies "noxec".
73 de Donn Washburn
Hubert Mantel -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
On 11/24/2009 08:08 AM, Hubert Mantel wrote:
Hi,
On Tue, Nov 24, Donn Washburn wrote:
No Sir! I even as a test set all of the files to 777 and it fails.
Also here is a strace conf.err output. It is short
You may have found it!!!!
/etc/fstab shows sdc1 as clear of noexec but /etc/mtab shows it. Where does mtab get its information?
Did you mount the partition as unprivileged user (option "user" in fstab)? "user" implies "noxec".
73 de Donn Washburn
Hubert Mantel
Thanks for the suggestion folks - Marcus and Hubert Yes! I will take it out of fstab and reboot. I did it because I thought it would allow a user to mount the noauto drive.. It is a plug in USB and would cause a long boot up if removed. -- 73 de Donn Washburn 307 Savoy Street Email:" n5xwb@comcast.net " Sugar Land, TX 77478 LL# 1.281.242.3256 Ham Callsign N5XWB HAMs : " n5xwb@arrl.net " VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg BMW MOA #: 4146 - Ambassador " http://counter.li.org " #279316 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
Hi, On Tue, Nov 24, Donn Washburn wrote:
Thanks for the suggestion folks - Marcus and Hubert
Yes! I will take it out of fstab and reboot. I did it because I thought it would allow a user to mount the noauto drive.. It is a plug in USB and would cause a long boot up if removed.
No need to drop the user option if it is useful for you. Just append the "exec" option, such as: user,exec. This will override the implicit noexec option, but it needs to come _after_ the user option.
73 de Donn Washburn
Hubert Mantel -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
On 11/24/2009 09:12 AM, Hubert Mantel wrote:
Hi,
On Tue, Nov 24, Donn Washburn wrote:
Thanks for the suggestion folks - Marcus and Hubert
Yes! I will take it out of fstab and reboot. I did it because I thought it would allow a user to mount the noauto drive.. It is a plug in USB and would cause a long boot up if removed.
No need to drop the user option if it is useful for you. Just append the "exec" option, such as: user,exec. This will override the implicit noexec option, but it needs to come _after_ the user option.
73 de Donn Washburn
Hubert Mantel
Well Thanks for Guru knowledge - I live in the Arm Pit of the World known as Houston area and Linux is not even used here. Winblows is about all you will see. I guess people enjoy spending money and chasing virus software. It is working again -- 73 de Donn Washburn 307 Savoy Street Email:" n5xwb@comcast.net " Sugar Land, TX 77478 LL# 1.281.242.3256 Ham Callsign N5XWB HAMs : " n5xwb@arrl.net " VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg BMW MOA #: 4146 - Ambassador " http://counter.li.org " #279316 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org
participants (3)
-
Donn Washburn -
Hubert Mantel -
Marcus Meissner