https://bugzilla.novell.com/show_bug.cgi?id=427111 https://bugzilla.novell.com/show_bug.cgi?id=427111#c30 --- Comment #30 from Prexy Prexy <bill@oldmillfarm.com> 2010-09-10 16:16:15 UTC --- I also tried to run "network settings" through yast2 while booted to failsafe, just in case it was a kde issue. Outcome was same; system freezes at detecting hardware. Output requested: hwinfo --wlan 14: PCI 207.0: 0282 WLAN controller [Created at pci.318] Unique ID: PL6s.yPceUqvgmU6 Parent ID: 6NW+.eDbWAYN5SdB SysFS ID: /devices/pci0000:00/0000:00:1e.0/0000:02:07.0 SysFS BusID: 0000:02:07.0 Hardware Class: network Model: "Realtek RTL-8185 IEEE 802.11a/b/g Wireless LAN Controller" Vendor: pci 0x10ec "Realtek Semiconductor Co., Ltd." Device: pci 0x8185 "RTL-8185 IEEE 802.11a/b/g Wireless LAN Controller" SubVendor: pci 0x10ec "Realtek Semiconductor Co., Ltd." SubDevice: pci 0x8185 Revision: 0x20 Driver: "rtl8180" Driver Modules: "rtl8180" Device File: wlan1 Features: WLAN I/O Ports: 0xe800-0xe8ff (rw) Memory Range: 0xfdeff400-0xfdeff7ff (rw,non-prefetchable) IRQ: 16 (no events) HW Address: 00:14:d1:33:fb:33 Link detected: yes WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 2.484 WLAN encryption modes: WEP40 WEP104 TKIP CCMP WLAN authentication modes: open sharedkey wpa-psk wpa-eap Module Alias: "pci:v000010ECd00008185sv000010ECsd00008185bc02sc00i00" Driver Info #0: Driver Status: rtl8180 is active Driver Activation Cmd: "modprobe rtl8180" Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #3 (PCI bridge) -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.