Comment # 90 on bug 1006175 from Martin Wilck

(In reply to Per Jessen from comment #89)

> I have a fresh installation of Leap421, 
> You mean: run the zypper dup to Leap422, then try to boot :
> 
> a) without DUD and
> b) without hpsa.hpsa_allow_any=1 and
> c) with cciss.cciss_allow_hpsa=0
> 
> Isn't the problem still going to be that the cciss module does not recognise
> the HP Smart Array 6i controller?

That's what I'd like to clarify. 

"cciss_allow_hpsa" is set to 1 by default. The meaning of flag (which is sort
of misnamed IMO) is "Prevent cciss driver from accessing hardware known to be
supported by the hpsa driver". Thus by setting the flag to 0, the cciss driver
might actually detect that hardware again.

... which would basically obsolete all 89 comments made on this bug so far.