Comment # 13 on bug 903889 from Michal Filka

(In reply to Knut Alejandro Anderssen Gonz�lez from comment #12)
> (In reply to Giacomo Comes from comment #10)
> > during the installation process the network configuration only uses a simple
> > network interface setup (no bridge). At the end of the installation process,
> > after all the rpm are installed and the final system configuration is
> > created, that is when you see on screen:
> > 
> > Save installation settings
> > * Saving network configuration...
> > 
> > in this moment in /mnt/etc/sysconfig/network are created the network files
> > that are used upon next reboot. There is ifcfg-br0, ifcfg-eth0 and the wrong
> > ifroute-eth0. 
> > I would say that it is the installer that when it decides to change the
> > saved network configuration (from non bridge to bridge because of the KVM
> > pattern getting installed) I does so correctly for the network interface but
> > it forgets to adjust the routing. In 13.1 this was done correctly. The bug
> > was introduced in 13.2.
> 
> I will take a look, but sounds reasonable to adjust also the routing.

sounds that routing is done before proposing virtual devices, if yes we need to
check and fix order (it might be a problem bcs virtual proposal is called from
"external" module)