Comment # 12 on bug 903889 from Knut Alejandro Anderssen Gonz�lez

(In reply to Giacomo Comes from comment #10)
> during the installation process the network configuration only uses a simple
> network interface setup (no bridge). At the end of the installation process,
> after all the rpm are installed and the final system configuration is
> created, that is when you see on screen:
> 
> Save installation settings
> * Saving network configuration...
> 
> in this moment in /mnt/etc/sysconfig/network are created the network files
> that are used upon next reboot. There is ifcfg-br0, ifcfg-eth0 and the wrong
> ifroute-eth0. 
> I would say that it is the installer that when it decides to change the
> saved network configuration (from non bridge to bridge because of the KVM
> pattern getting installed) I does so correctly for the network interface but
> it forgets to adjust the routing. In 13.1 this was done correctly. The bug
> was introduced in 13.2.

I will take a look, but sounds reasonable to adjust also the routing.