On the Raspberry Pi 2 I use Leap 15.0 which is fully updated. During boot I see
the following (error) messages on the console:

Failed (-5)
In:    serial
Out:   vidconsole
Err:   vidconsole
Net:   No ethernet found.
starting USB...
USB0:   Core Release: 2.80a
scanning bus 0 for devices... error in inquiry
4 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot:  0 
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
Found EFI removable media binary efi/boot/bootarm.efi
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
Scanning disk mmc@7e202000.blk...
Found 4 disks
544256 bytes read in 25 ms (20.8 MiB/s)
libfdt fdt_check_header(): FDT_ERR_BADMAGIC
## Starting EFI application at 01000000 ...
Welcome to GRUB!

error: file `/boot/grub2/fonts/unicode.pf2' not found.

Welcome to openSUSE Leap 15.0 dracut-044-lp150.14.12.1 (Initramfs)!

[ other messages ...]

[  OK  ] Started Load Kernel Modules.
[FAILED] Failed to start Setup Virtual Console.
See 'systemctl status systemd-vconsole-setup.service' for details.
[DEPEND] Dependency failed for dracut ask for additional cmdline parameters.