There should be a command line available on vt9 even this early.

anybody? I'm still dead-in-the-water. anybody seen this? any debug tips?

thanks.

-----Original Message----- From: Jorge Alvarado [mailto:jalvarado@pervasive.com] Sent: Tuesday, January 09, 2007 6:08 PM To: opensuse-autoinstall@opensuse.org Subject: [SPAM] - [opensuse-autoinstall] autoinstall fails with exit code 11 - Email found in subject

Hi list, anybody seen this before?

install gets kicked off, then get a error pop up. the console shows the following; http: //192.../install/se9/content 640 bytes http: //192.../install/se9/media.1/info.txt 13422 bytes http: //192.../install/se9/control.xml 17722 bytes Loading "/install/se9/driverupdate" ramdisk /dev/ram3 freed starting setctsid "showconsole" inst_setup yast install program exit code is 11

I added y2debug to the boot parameters, but see no other debug info. No command line, probably too early in the install, so can't look at y2logs, etc.

any help appreciated. thanks, Jorge

-- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org

-- To unsubscribe, e-mail: opensuse-autoinstall+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-autoinstall+help@opensuse.org