Drive shows up correctly. It's a SATA drive connected to the ICH5 controller port on board. Doing a manual install worked fine (drive detection, partioning, etc). Fails with the profile, though.
It is downloading the profile via ftp from our server (wish I could make it a linux server). It just fails on the partion config section. Attached is my /var/log/Yast2 directory (tarball). The only error I can find is from parted (lines 256,257). Am I missing something?
Tobin
Uwe Gansert <ug@suse.de> wrote:
On Friday 12 August 2005 20:30, GrueMaster wrote:
> To start, I just want to complete an install. Here's my basic.xml file
> (sans post-install script).
your profile is working fine here with a 9.3.
Do you have any hardware that might not be getting detected?
For example, when you see the error box, switch to the console and check if
your harddisk is accessible via fdisk.
--
ciao, Uwe Gansert
Uwe Gansert, Server Technologies Team
SUSE LINUX Products GmbH, Maxfeldstrasse 5, D-90409 Nürnberg, Germany
e-mail: uwe.gansert@suse.de, Tel: +49-(0)911-74053-0,
Fax: +49-(0)911-74053-476, Web: http://www.suse.de
--
To unsubscribe, e-mail: suse-autoinstall-unsubscribe@suse.com
For additional commands, e-mail: suse-autoinstall-help@suse.com