Hello,
this is an easy one:
you did not enter the moutpoint correctly! This is the Way I did it and it works...
<partition>
<size>500mb</size>
<mount>swap</mount>
<filesystem config:type="symbol" >swap</filesystem>
<format config:type="boolean" >true</format>
</partition>
Hope that helps
Thorsten
-----Original Message-----
From: Volkmar Glauche
To: suse-autoinstall@suse.com
Sent: 26.09.2002 11:59
Subject: [suse-autoinstall] Partitioning/swap
Hi,
last time I reported problems with creating and mounting swap partitions
in connection with lvm setup. This time it is a single disk, ide setup,
but the same problem. Yast says during partitioning, that it is creating
a
filesystem for "/" on both /dev/hde5 and /dev/hde6, where only /dev/hde6
is used for "/" in reality. /dev/hde5 should have become a swap
partition,
but it is neither initialised nor the corresponding entry added to
/etc/fstab. Does anyone out there have suggestions what might be wrong
in
the attached code snippet?
Thanks very much,
--
Volkmar Glauche
Department of Neurology E-Mail glauche@uke.uni-hamburg.de
UKE Hamburg WWW http://glauche.home.pages.de/
Martinistr. 52 Phone 49(0)40-42803-5781
20246 Hamburg Fax 49(0)40-42803-9955
*** eSafe scanned this email for malicious content ***
*** IMPORTANT: Do not open attachments from unrecognized senders ***
<