I'm looking for some pointers on how to figure out why grub is hanging during autoyast install.
The profile was created on the target system after installing from the OpenSuSE 11 DVD. Pretty much all options and package selections were the default. I did update to autoyast2-2.16.19-0.1 to generate the profile, as the installed version appeared to go into an infinite loop trying to resolve package dependencies.
After wiping the disk, and starting a network install with that profile, it hangs installing the grub rpm post install scriptlet. If I kill that process and run the grub script by hand it succeeds, and the autoyast apparently proceeds normally. I've tried several variations of this all with the same result.
The command in the script that hangs is: /usr/sbin/grub --batch < /etc/grub.conf >/dev/null 2>&1 and grub.conf is: setup --stage2=/boot/grub/stage2 (hd0) (hd0,1) quit
The only thing at all unusual about the system is that boot/root disk is a hardware raid array managed by an LSISAS1068E chip on the motherboard. There is only one target, and that is correctly labeled as /dev/sda. /dev/sda1 is swap, and /dev/sda2 is root (with XFS filesystem). But this all works normally with a DVD install.
Any pointers on how to track this down would be greatly appreciated.