Freek, Unfortunally - no success! Her'e my outputs: ./sd-card.sh 2+0 records in 1024+0 records out 1024 bytes (1.0 kB, 1.0 KiB) copied, 0.00331344 s, 309 kB/s # df -h /dev/sdf1 Filesystem Size Used Avail Use% Mounted on /dev/sdf1 31G 16K 31G 1% /run/media/root/A402-8523 # xzcat openSUSE-Leap42.3-ARM-JeOS-raspberrypi3.aarch64-2017.07.26-Build1.1.raw.xz | dd bs=4M of=/dev/sdf1 iflag=fullblock oflag=direct; sync 383+1 records in 383+1 records out 1607467008 bytes (1.6 GB, 1.5 GiB) copied, 136.038 s, 11.8 MB/s # df -h /dev/sdf1 Filesystem Size Used Avail Use% Mounted on /dev/sdf1 31G 16K 31G 1% /run/media/root/A402-8523 Shouldn't be a difference there before/after? # fdisk -l /dev/sdf Disk /dev/sdf: 30.2 GiB, 32395755520 bytes, 63272960 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0x00006e4d Device Boot Start End Sectors Size Id Type /dev/sdf1 * 2048 63272958 63270911 30.2G c W95 FAT32 (LBA) Board doesn't boot. SD-card is new an working well with different filesystems, when formatted. Regards Am 26.07.18 um 17:25 schrieb Freek de Kruijf:
Op donderdag 26 juli 2018 17:14:38 CEST schreef Sten Bert:
Thank you for the fast reply! Of course. - But that was the only path that was working rudimental and promised a similar way as on x86-PC. The section marked as(easiest)dind't work at all- rainbow screen! Maybe there's a hint missing about the preparation of the sd-card? You may need to clear the highest blocks on the SD card.
I use in bash:
dev=sdX ssize=$(/usr/sbin/blockdev --getss /dev/$dev) [ $ssize -ne 512 ] && echo "Sector size not equal 512" && exit 1 size=$(/usr/sbin/blockdev --getsz /dev/$dev) dd if=/dev/zero of=/dev/$dev obs=1 seek=$(($size - 2)) count=2
-- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org