From: Michael Ströder <michael(a)stroeder.com>
Sent: 11 September 2019 16:17
To: Guillaume Gardet <Guillaume.Gardet(a)arm.com>om>; openSUSE ARM ML
Subject: Re: [opensuse-arm] RPI1 does not boot after Tumbleweed upgrade
On 9/11/19 3:53 PM, Guillaume Gardet wrote:
Michael Ströder <michael(a)stroeder.com>
Sent: 11 September 2019 13:55
On 9/11/19 1:47 PM, Guillaume Gardet wrote:
>> -----Original Message-----
>> From: Michael Ströder <michael(a)stroeder.com>
>> Sent: 11 September 2019 13:34
>> I'm running Tumbleweed on RPI1 (armv6). It does not boot after last
>> upgrade to kernel from 5.2.10 to 5.2.13. During upgrade there were
>> no error messages.
> Did you update the kernel only, or the whole distribution (maybe
I did the usual full upgrade with
zypper dup -l --no-allow-vendor-change --no-recommends
Did you run out of space, maybe?
No. There's plenty of space on the partitions:
- The firmware partition still has 15MB available and 1.5M used.
- On the OS partition (where's /boot) 4.9GB are still available.
If the rainbow screen is not display, this means
that the firmware is
IIRC, there was a firmware update with latest
Can I check whether the firmware files are complete?
I read again your 1st email and it seems that you are missing the firmware
files on the 1st partition of your SD card.