RE: [opensuse-arm] libgpiod on RasPi 3B+ apparently does not work

Hi,

-----Original Message----- From: Simon Gleissner Sent: 10 March 2019 22:32 To: opensuse-arm@opensuse.org Subject: [opensuse-arm] libgpiod on RasPi 3B+ apparently does not work

I'm using Tumbleweed JeOS (20190308, aarch64) on a RaspberryPI 3B+, which works astonishingly good and stable.

During my attempts to use the GPIOs with libgpiod, i've found that the GPIOs are not named as they should be. Also setting GPIOs does not seem to work, if they are changed with gpioset.

Regarding the naming of the GPIOs, all of them are unnamed:

I think it is because we use an upstream kernel which does not name it. I guess this would not be too difficult to get it, but someone need to make the patch and upstream it.

# gpioinfo pinctrl-bcm2835 gpiochip0 - 54 lines: line 0: unnamed unused input active-high line 1: unnamed unused input active-high line 2: unnamed unused input active-high line 3: unnamed unused input active-high line 4: unnamed unused input active-high ... line 29: unnamed "led0" output active-high [used] line 30: unnamed unused output active-high line 31: unnamed unused output active-high ... line 47: unnamed unused output active-high ...

There are references for Raspian, that the 'unnamed' entries should contain the GPIO names, e.g. at https://www.beyondlogic.org/an-introduction-to- chardev-gpio-and-libgpiod-on-the-raspberry-pi/ .

Also the "led0" and other output-GPIOs do not match in their position. It seems that there is a mismatch in the device tree and I think the Tumbleweed kernel uses a generic .dts config file, whereas Raspian uses an adapted one.

It should match just fine. On my RPi3 B, it does match.

I have checked the mailing list and found, that the problem is not new: https://lists.opensuse.org/opensuse-arm/2018-09/msg00000.html

I also have found an article in the opensuse wiki, which describes the functionality, but does not help with the mapping: https://en.opensuse.org/openSUSE:GPIO

Additionally, I have tried setting all possible GPIOs with libgpiod's gpioset (some of them crashed the system), but it was not possible to change the GPIO output (I've connected a LED). However, with the deprecated sysfs GPIO subsystem this worked instantly without any problems (with offset N=458).

I have updated this wiki page now to use '--mode=wait' option. Otherwise, this tool set the GPIO to 1 and exit immediately and release the GPIO and does not set it anymore and you will not notice that anything happened. With wait mode, press ctrl-c to stop setting the value.

Question: did anyone here succeeded in using libgpiod for setting GPIOs in Tumbleweed yet?

On Tumbleweed 20190308, with my RPi3 B, the following command just works to set GPIO26 to 1 (3V3) : gpioset --mode=wait gpiochip0 26=1 Could you test the '--mode=wait' option, please? Thanks, Guillaume IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium. Thank you. N�����r��y隊Z)z{.�櫛맲��r��z�^�ˬz��N�(�֜��^� ޭ隊Z)z{.�櫛�0�����Ǩ�