Am 12.07.19 um 17:53 schrieb Knurpht-openSUSE:
Op vrijdag 12 juli 2019 16:35:33 CEST schreef Bernd Nachtigall:
After I install openSUSE-Leap-15.1-ARM-XFCE-raspberrypi3.aarch64-2019.05.17-Snapshot1.18. raw .xz to a RasPi I get a IP via DHCP during the first boot.
Then I configure a fix IP via YaST. But this fix IP is configured as secondary IP. Even if I remove the interface configuration and renew it with the fix IP - after the YaST config runs throught, there are a interface with a primary addess from DHCP and a additional secondary IP from the fixed config.
Where i can change this tricky behavior?
Bernd
Please show some confirmation: ip addr
mon:/etc/sysconfig/network # ip a s 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether b8:27:eb:8d:5b:c2 brd ff:ff:ff:ff:ff:ff inet 192.168.250.181/25 brd 192.168.250.255 scope global noprefixroute dynamic eth0 valid_lft 2816sec preferred_lft 2816sec inet 192.168.250.185/25 brd 192.168.250.255 scope global secondary noprefixroute eth0 valid_lft forever preferred_lft forever inet6 fe80::c369:b4f2:7cdc:133c/64 scope link noprefixroute valid_lft forever preferred_lft forever 3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000 link/ether d2:f6:86:b8:bd:70 brd ff:ff:ff:ff:ff:ff
With this config it is not possible to connect to the I-Net. When I delete .181 the connection is possible but after a while dhcp is rising again.
Bernd How do you configure it? Looks like you added a connection instead of editing
Op vrijdag 12 juli 2019 19:03:48 CEST schreef Bernd Nachtigall: the existing one. -- Gertjan Lettink a.k.a. Knurpht openSUSE Board Member openSUSE Forums Team -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org