Mailinglist Archive: opensuse (389 mails)

< Previous Next >
Re: [opensuse] how to determine actual SATA speed ?
21.03.2019 21:31, Per Jessen пишет:
Andrei Borzenkov wrote:

21.03.2019 14:44, Per Jessen пишет:
# dmesg | grep -i sata
[3.552297] ata1: SATA max UDMA/133 cmd 0x1f0 ctl 0x3f6 bmdma 0x30b0
irq14
[3.552459] ata2: SATA max UDMA/133 cmd 0x170 ctl 0x376 bmdma 0x30b8
[irq15


This just tells you that controller (probably, ULi) was found. If
there are no "SATA link up" messages, are you sure your disks are
actually connected to this controller?

No, but they are connected to _something_. :-)


Your controller runs in IDE emulation mode, so no SATA specific
information.

00:1f.2 IDE interface [0101]: Intel Corporation NM10/ICH7 Family SATA
Controller [IDE mode] [8086:27c0] (rev 01)
Subsystem: Super Micro Computer Inc Device [15d9:8580]
Kernel driver in use: ata_piix
Kernel modules: ata_piix, pata_acpi, ata_generic


[ 3.735384] ata2.00: ATA-7: WDC WD800AAJS-00PSA0, 05.06H05, max UDMA/133
[ 3.735553] ata2.00: 156301488 sectors, multi 16: LBA48 NCQ (depth 0/32)
[ 3.741064] ata2.00: configured for UDMA/133

--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
To contact the owner, e-mail: opensuse+owner@xxxxxxxxxxxx

< Previous Next >
Follow Ups