Mailinglist Archive: opensuse (3065 mails)

< Previous Next >
Re: [opensuse] cannot connect to WLAN
  • From: Daniel Bauer <linux@xxxxxxxxxxxxxxxx>
  • Date: Tue, 3 Jun 2008 16:30:42 +0200
  • Message-id: <200806031630.42146.linux@xxxxxxxxxxxxxxxx>
On Tuesday 03 June 2008 15:33:50, Gabriel Stein wrote:
Hey Daniel,

And your config to dns and gateway? Are ok?

Please print here the results of 2 commands:

"cat /etc/resolv.conf"

daniel@dhcppc0:~> cat /etc/resolv.conf
### BEGIN INFO
#
# Modified_by: NetworkManager
# Process: /usr/bin/NetworkManager
# Process_id: 11276
#
### END INFO

nameserver 80.58.61.250
nameserver 80.58.61.254


and AFTER

"route -n"

dhcppc0:~ # route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0


(this now, I am connected by cable, so there's eth0 while WLAN would be
eth1...)

I found a KNetworkManager-Log in /var/log. Just now I tried to activate the
WLAN and thats the result in that log:

Jun 3 16:26:02 baer NetworkManager: <debug> [1212503162.016064]
nm_device_802_11_wireless_get_activation_ap(): Forcing AP 'WLAN_A0'
Jun 3 16:26:02 baer NetworkManager: <info> User
Switch: /org/freedesktop/NetworkManager/Devices/eth1 / WLAN_A0
Jun 3 16:26:02 baer NetworkManager: <info> Deactivating device eth1.
Jun 3 16:26:02 baer NetworkManager: <info> Device eth1 activation
scheduled...
Jun 3 16:26:02 baer NetworkManager: <info> Deactivating device eth0.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) started...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) scheduled...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) started...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) scheduled...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) complete.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) starting...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1/wireless):
access point 'WLAN_A0' is encrypted, but NO valid key exists. New key
needed.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) New wireless
user key requested for network 'WLAN_A0'.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) complete.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) New wireless
user key for network 'WLAN_A0' received.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) scheduled...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) started...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) scheduled...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) complete.
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) starting...
Jun 3 16:26:03 baer NetworkManager: <info> Activation (eth1/wireless):
access point 'WLAN_A0' is encrypted, and a key exists. No new key needed.
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending
command 'INTERFACE_ADD eth1 wext /var/run/wpa_supplicant '
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'AP_SCAN 1'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending
command 'ADD_NETWORK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was '0'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'SET_NETWORK
0 ssid 574c414e5f4130'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'SET_NETWORK
0 scan_ssid 1'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'SET_NETWORK
0 key_mgmt NONE'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'SET_NETWORK
0 wep_key0 <key>'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending command 'SET_NETWORK
0 wep_tx_keyidx 0'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: sending
command 'ENABLE_NETWORK 0'
Jun 3 16:26:04 baer NetworkManager: <info> SUP: response was 'OK'
Jun 3 16:26:04 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) complete.
Jun 3 16:26:27 baer NetworkManager: <debug> [1212503187.573753]
nm_device_802_11_wireless_get_activation_ap(): Forcing AP 'WLAN_A0'
Jun 3 16:26:27 baer NetworkManager: <info> User
Switch: /org/freedesktop/NetworkManager/Devices/eth1 / WLAN_A0
Jun 3 16:26:27 baer NetworkManager: <info> Deactivating device eth1.
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1): cancelling...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) cancellation
handler scheduled...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1): waiting for
device to cancel activation.
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) cancellation
handled.
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1): cancelled.
Jun 3 16:26:27 baer NetworkManager: <info> Device eth1 activation
scheduled...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) started...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) scheduled...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) started...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) scheduled...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) Stage 1 of 5
(Device Prepare) complete.
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) starting...
Jun 3 16:26:27 baer NetworkManager: <info> Activation (eth1/wireless):
access point 'WLAN_A0' is encrypted, and a key exists. No new key needed.
Jun 3 16:26:30 baer NetworkManager: <info> Error opening supplicant global
control interface.
Jun 3 16:26:30 baer NetworkManager: <WARN> real_act_stage2_config():
Activation (eth1/wireless): couldn't connect to the supplicant.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth1) failure
scheduled...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth1) Stage 2 of 5
(Device Configure) complete.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth1) failed for
access point (WLAN_A0)
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth1) failed.
Jun 3 16:26:30 baer NetworkManager: <info> Deactivating device eth1.
Jun 3 16:26:30 baer NetworkManager: <info> SWITCH: no current connection,
found better connection 'eth0'.
Jun 3 16:26:30 baer NetworkManager: <info> Will activate connection 'eth0'.
Jun 3 16:26:30 baer NetworkManager: <info> Device eth0 activation
scheduled...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) started...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 1 of 5
(Device Prepare) scheduled...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 1 of 5
(Device Prepare) started...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 2 of 5
(Device Configure) scheduled...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 1 of 5
(Device Prepare) complete.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 2 of 5
(Device Configure) starting...
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 2 of 5
(Device Configure) successful.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 3 of 5
(IP Configure Start) scheduled.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 2 of 5
(Device Configure) complete.
Jun 3 16:26:30 baer NetworkManager: <info> Activation (eth0) Stage 3 of 5
(IP Configure Start) started...
Jun 3 16:26:31 baer NetworkManager: <info> Activation (eth0) Beginning DHCP
transaction.
Jun 3 16:26:31 baer NetworkManager: <info> Activation (eth0) Stage 3 of 5
(IP Configure Start) complete.
Jun 3 16:26:31 baer NetworkManager: <info> DHCP daemon state is now 12
(successfully started) for interface eth0
Jun 3 16:26:31 baer NetworkManager: <info> DHCP daemon state is now 1
(starting) for interface eth0

So there was an error and then it fell back to the cable on eth0. That's all I
can see from this log. Maybe you see more?

regards

Daniel


--
Daniel Bauer photographer Basel Barcelona
professional photography: http://www.daniel-bauer.com
erotic art photos: http://www.bauer-nudes.com
Madagascar special: http://www.fotograf-basel.ch/madagascar/
--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx

< Previous Next >
Follow Ups