Mailinglist Archive: opensuse (4547 mails)

< Previous Next >
Re: [SLE] Setting resolv.conf with DHCP
  • From: Marek Chlopek <emcek2@xxxxxxxxxxxxxx>
  • Date: Sat, 22 May 2004 08:10:03 +0200
  • Message-id: <200405220810.04057.emcek2@xxxxxxxxxxxxxx>
On Friday, 21 of May 2004 22:24, Craig Altenburg wrote:
> I have two ethernet interfaces, eth0 (wired 10/100) and wlan0
> (wireless).
>
> If I boot my machine at home where I have a wireless LAN it works fine.
>
> If I boot at work (where there is no wireless lan) with the ethernet
> cable plugged the DHCP picks up the IP address and the default route
> but does not replace the resolv.conf settings. Oddly, if I do an
> ifdown on both eth0 and wlan0 then do an ifup on just eth0 it works.
>
> Is there anything I can do too make this work automatically?

scpm is your friend - read suse administrator guide
use profile when booting

--
Marek Chlopek

< Previous Next >
References