Mailinglist Archive: opensuse (4547 mails)

< Previous Next >
Re: [SLE] SuSE 9.1 installation on Adaptec Raid with dtp_i2o driver
  • From: Joseph Brockert <joe@xxxxxxxxxxxx>
  • Date: Wed, 12 May 2004 15:40:00 -0500
  • Message-id: <1084394400.2887.19.camel@xxxxxxxxxxx>
Are you suggesting that when the yast probe finds the the raid card and
and recommends loading the dpt_i2o driver that I say no and continue
on?, or is their a setting on the card itself that I need to
disable?....thanks joe


On Wed, 2004-05-12 at 14:55, g.lams@xxxxxxxxxx wrote:
>
>
>
> I had the same kind of problem on an "old" integrated and I had to disable
> i2o on the raid adapter. I also had to pass 2 parameters at boot time but
> disabling i2o could be enough
>
> gael
>
> -----Joseph Brockert <joe@xxxxxxxxxxxx> wrote: -----
>
> >To: suse-linux-e@xxxxxxxx
> >From: Joseph Brockert
> >Date: 12/05/2004 09:06PM
> >Subject: [SLE] SuSE 9.1 installation on Adaptec Raid with dtp_i2o
> >driver
> >
> >I boot to SuSE install dvd and start a manual install. Yast finds my
> >adaptec(dtp) 2000 raid card and ask to load the dpt_i20 drivers, I
> >say
> >OK. Yast continues but says it can find any hard disks. I know hards
> >are
> >installed, because I have formated them up, install SuSE 9.0, then
> >reformated. This same process works OK with SuSE 9.0 installation.
> >I
> >have tried just installing to a single disk, or a raid setup, but
> >the
> >intallation never finds any disks. Can anyone give me an idea where
> >to
> >look next?.....joe
> >
> >
> >--
> >Check the headers for your unsubscription address
> >For additional commands send e-mail to suse-linux-e-help@xxxxxxxx
> >Also check the archives at http://lists.suse.com
> >Please read the FAQs: suse-linux-e-faq@xxxxxxxx
>


< Previous Next >
Follow Ups
References