Mailinglist Archive: opensuse (3217 mails)

< Previous Next >
Re: [SLE] Getting a SCSI bug:
  • From: "Ken Schneider" <suselist@xxxxxxxx>
  • Date: Sun, 29 Feb 2004 20:25:27 -0500
  • Message-id: <WorldClient-F200402292025.AA25270458@xxxxxxxx>
-----Original Message-----
From: Bruce Marshall <bmarsh@xxxxxxxxxx>
To: SLE <suse-linux-e@xxxxxxxx>
Date: Sun, 29 Feb 2004 18:52:59 -0500
Subject: Re: [SLE] Getting a SCSI bug:

> On Sunday 29 February 2004 06:39 pm, Hans Forbrich wrote:
> > Hi,
> >
> > I just added an Adaptec 29160 and a used Benchmark VS80/DLT1 (aka
> Quantum
> > VS80 & Dell PowerVault 110T) to my SuSE SLES8 machine. On boot I get
> the
> > message at the bottom (as well as other messages - don't want to
> clutter
> > this list).
> >
> > Any comments, advice, etc. appreciated.
> >
> > TIA/Hans
> >
> > from DMESG ....
> >
> > scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.29
> > <Adaptec 29160 Ultra160 SCSI adapter>
> > aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
> >
> > blk: queue f7fbde14, I/O limit 4095Mb (mask 0xffffffff)
> > scsi0:A:3:0: DV failed to configure device. Please file a bug report
> > against this driver.
> > (scsi0:A:3): 20.000MB/s transfers (10.000MHz, offset 15, 16bit)
> > Vendor: BNCHMARK Model: DLT1 Rev: 391B
> > Type: Sequential-Access ANSI SCSI revision: 02
> > blk: queue f7fbda14, I/O limit 4095Mb (mask 0xffffffff)
>
> Have you checked all of the settings on the controller? And were
> there any
> error messages during POST at boot up?
>

This setup should not produce any errors and correctly shows that the tape
drive can do 20MB/s. Add a couple of 169MB/s drives and you will have a
very fast files system as well.

Ken



< Previous Next >
List Navigation
Follow Ups