http://bugs.freedesktop.org/show_bug.cgi?id=16929
--- Comment #14 from Egbert Eich
Did a git pull this morning. Tried different setups to get a picture using RandR, no luck.
I used the modes line with NoRandR and that works. I also tried it earlier with a virtual line. The effect is the same. I get picture at 1920x1080, but the image seems slightly too big for the tv. The left, right and bottom edges fall off screen.
Does the picture 'scroll' when you move the mouse to the edges?
I did notice however that if I connect an 15" (1024x768) lcd to the DVI interface, the picture is cloned to the tv in RandR mode. But whatever I try with xrandr, I can't get the right resolution on the tv. If I disconnect the
OK, what resolution do you get on the TV?
15" and use xrandr again, the picture on the tv goes black.
Can you send a verbose log file for this case? - ie where you first use the 15", then pull it off, then do xrandr again?
So it seems there's some load detection problem on the HDMI connector.
There is no load detection on your HDMI connector. Everything there looks well - except that you get a black screen. -- Configure bugmail: http://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the QA contact for the bug. _______________________________________________ xorg-team mailing list xorg-team@lists.x.org http://lists.x.org/mailman/listinfo/xorg-team -- To unsubscribe, e-mail: radeonhd+unsubscribe@opensuse.org For additional commands, e-mail: radeonhd+help@opensuse.org