Mailinglist Archive: radeonhd (400 mails)

[Luc Verhaegen <libv@xxxxxxxxx>]

On Tue, Sep 25, 2007 at 01:46:21PM +0200, Miha Pavlin wrote:
> 
> 
> -------- Original Message --------
> Subject:        Re: [radeonhd] radeonhd Xorg.log
> Date:   Fri, 21 Sep 2007 12:50:34 +0200
> From:   Miha Pavlin <miha@xxxxxx>
> To:     pageexec@xxxxxxxxxxx
> References:     <200709202145.28193.miha@xxxxxx>, 
> <46F3ACF8.29251.24DFB2A5@xxxxxxxxxxxxxxxxxxxx>, 
> <46F393AD.5010803@xxxxxx> <46F3BAA2.22712.251515F4@xxxxxxxxxxxxxxxxxxxx>
> 
> 
> 
> yes, almost there :)
> 
> another error -> monitor doesn't support reduced blanking
> 
> BR, Miha
> 
> pageexec@xxxxxxxxxxx wrote:
> >On 21 Sep 2007 at 11:49, Miha Pavlin wrote:
> >
> >  
> >>same error at the end.... Xorg.log is attached if it helps
> >>    
> >
> >ok, for some reason your system is almost there (mine's not ;), add
> >
> >    HorizSync    30-120
> >    VertRefresh  59-61
> >
> >to your Monitor section and you should see something. one difference
> >i spotted was that your ATOMBIOS reported BR21540.BIN while mine says
> >it has Test.bin - can you grab/post your video ROM please:
> >
> >    dd if=/dev/mem of=nc8430.rom bs=1k count=64 skip=768
> >
> >
> >  
> 


> (--) RADEONHD(0): Detected an M56 on a HP/Compaq nc8430

Ok, so a known device.

> (II) RADEONHD(0): Detected VGA mode.
> (II) RADEONHD(0): Maximum Pixel ClockPLL Frequency Output: 110000
> (--) RADEONHD(0): Detected a 18bit dual link panel.
> (--) RADEONHD(0): Attaching Output LVDS/TMDS to Connector Panel
> (--) RADEONHD(0): Attaching Output DAC A to Connector VGA
> (II) RADEONHD(0): I2C device "RHD I2C line 0:ddc2" registered at address 0xA0.
> (II) RADEONHD(0): I2C device "RHD I2C line 0:ddc2" removed.
> (II) RADEONHD(0): No EDID data found on connector "Panel"

Hrm.

> (II) RADEONHD(0): Configured Monitor "aticonfig-Monitor[0]":
>     Bandwidth:0MHz
>     Horizontal timing:
>         30.0 - 120.0kHz
>     Vertical timing:
>         59.0 - 61.0Hz
>     Attached modes:

This is where we go wrong... One shouldn't use a configured monitor in 
this case, it doesn't help at all when the panel information is not 
known anyway.

We hope to have the DDC issue fixed today, egbert is busy testing his 
changes. We also hope to have the atombios information for panels before 
the weekend. This should fix this issue you are seeing now.

Thanks,
Luc Verhaegen.
SUSE/Novell X Driver Developer.
-- 
To unsubscribe, e-mail: radeonhd+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: radeonhd+help@xxxxxxxxxxxx