В Mon, 8 Dec 2014 17:58:03 +0200
Mark Goldstein
On Mon, Dec 8, 2014 at 4:29 PM, Anton Aylward
wrote: On 12/07/2014 11:52 PM, Mark Goldstein wrote:
What bothers me more are some shreds of IPv6. As I said, I disabled it (in Yast), then I manually disabled services like ip6tables and dhcp6, and I still see during power up and down the messages about IPv6 addresses configuration for my NIC. It causes power down delay, between other things.
Isn't there a way to disable it on the command line?
IIR there's also a config file of equivents... I think that /etc/sysctl.conf where I have
net.ipv6.conf.all.disable_ipv6 = 1
It is the same here, net.ipv6.conf.all.disable_ipv6 =1
wicked show-xml all produces <ipv6> <enabled>false</enabled> <forwarding>false</forwarding> <accept-ra>host</accept-ra> <autoconf>true</autoconf> <privacy>prefer-temporary</privacy> <accept-redirects>true</accept-redirects> </ipv6> for all interfaces.
And still I see during powering up:
[ 39.190148] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready [ 40.813486] IPv6: ADDRCONF(NETDEV_CHANGE): enp2s0: link becomes ready
Why IPv6 is doing something? Should I re-build initramfs? More voodoo? Something smells bad here. If IPv6 was disabled in YaST, I would not expect any IPv6-related leftovers.
try adding ipv6.disable=1 to kernel command line. You can alternatively add ipv6.autoconf=0 to disable autoconf. As ipv6 is built in, the only way to set it early enough is to use kernel parameter. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org