I have been looking for information on this but do not see it. Is it possible to set up (install new) activities when installing software. For example, in out software suite, it could be interesting to have a calibration activity, a diagnostics activity, a measurement activity, and an analysis activity. These never occur at the same time, use different tools, an could perhaps benefit from desktop streamlining when that activity is active. This will probably never happen if we need to set these up by hand. If, however, we could (1) detect if the activity is already defined so we do not muck up an already installed activity, and (2) install an activity that does not exist, we could then justify investigating the use of activities in our systems. Any pointers are welcome. Yours sincerely, Roger Oberholtzer OPQ Systems / Ramböll RST Office: Int +46 10-615 60 20 Mobile: Int +46 70-815 1696 roger.oberholtzer@ramboll.se ________________________________________ Ramböll Sverige AB Krukmakargatan 21 P.O. Box 17009 SE-104 62 Stockholm, Sweden www.rambollrst.se -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org