Mailinglist Archive: opensuse (946 mails)

[Roger Oberholtzer <roger@xxxxxx>]

I have a new openSUSE 11.2 system with this display:

        DELL P170S 17" TFT

The graphics in the system (cannot change it...) is a ATI chipset with
only a VGA connector.

X says this on the system:

(II) RADEON(0): Found color CRT connected to primary DAC
(II) RADEON(0): Output: VGA-0, Detected Monitor Type: 1
(II) RADEON(0): Total number of valid Screen mode(s) added: 0
(II) RADEON(0): Output: DVI-0, Detected Monitor Type: 0
(II) RADEON(0): Output VGA-0 connected
(II) RADEON(0): Output DVI-0 disconnected
(II) RADEON(0): Using fuzzy aspect match for initial modes
(II) RADEON(0): Output VGA-0 using initial mode 1024x768

In fact, the display can operate at 1280x1024. But as autodetection is
not functioning, it is operating in 1024x768. Does anyone just happen to
have the mode lines and all for this monitor? I would previously have
used SaX for this, but...


-- 
Roger Oberholtzer

OPQ Systems / Ramböll RST

Ramböll Sverige AB
Krukmakargatan 21
P.O. Box 17009
SE-104 62 Stockholm, Sweden

Office: Int +46 10-615 60 20
Mobile: Int +46 70-815 1696

-- 
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx