I just upgraded my 160GB hdd to 500GB on my ThinkPad T60 and everything was fine with my original 2 distros. fdisk -l listed with no errors. I installed 5 new distros including OpenSuse 11.3 Suse works fine but now: # fdisk -l now reads: Disk /dev/sda: 500.1 GB, 500107862016 bytes 255 heads, 63 sectors/track, 60801 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sda1 * 1 6374 51196288+ 7 HPFS/NTFS Partition 1 does not end on cylinder boundary. /dev/sda2 6374 7167 6365520 c W95 FAT32 (LBA) Partition 2 does not end on cylinder boundary. /dev/sda3 7167 8670 12073320 c W95 FAT32 (LBA) Partition 3 does not end on cylinder boundary. /dev/sda4 8670 60802 418751369+ f W95 Ext'd (LBA) /dev/sda5 8670 8798 1028128+ 82 Linux swap / Solaris /dev/sda6 8798 13897 40960048+ 83 Linux /dev/sda7 13897 18996 40960048+ 83 Linux /dev/sda8 18996 19379 3076888+ 83 Linux /dev/sda9 19379 23204 30723808+ 83 Linux /dev/sda10 23204 27029 30723808+ 83 Linux /dev/sda11 27030 27794 6144831 83 Linux /dev/sda12 27795 28559 6144831 83 Linux /dev/sda13 28560 29324 6144831 83 Linux sda6, sda7, sda8, and sda9 end at cylinder and the next partition starts at same cylinder as the previous cylinder. The next partition should start at the next cylinder as sda10,sda11,sda12 and sda13. How can I correct this? Does testdisk correct this, is it safe to use? jozien -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org