Hi dear all, I have some problem to install the suse 10.3 on raid 1. I got the PC(9088-BFG) with PCIE adaptec raid controller (Adaotec 1220SA Fanukty Controller #0) and two WD 160G SATA HDD . Below is my step: 1: power on the black box the go to the Adaptec RAID configuration Utility , Create a new array as RAID 1 and symbol as bootable. 2: Start with the SUSE 10.3 media , then next..next ...next ....at the partition windows ,there's three disk /dev/mapper/ddfi-******* BOIS RAID /dev/sda ...........WDC 160G HDD /dev/sdb ...........WDC 160G HDD I create the new partition(/SWAP /BOOT /)on the BIOS raid ,and then next ...every thing is OK After the installation is completed ,I can go to the KDE gui. But it can no load the media at the next start without the CD media ,it shows "No operation system". If I put the CD into the CD-ROM ,then the system can be loaded smoothly. Regards Kalvin Weng AT&S (China) Co.,Ltd Tel.: +86 21 24080509 Email: k.weng@cn.ats.net This e-mail and any attachment may contain confidential and/or privileged information. If you are not the intended recipient (or have received this e-mail in error) please notify the sender immediately and destroy this e-mail. Any unauthorised copying, disclosure or distribution of the material in this e-mail is strictly forbidden. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org