Hi all you guys ! I'm doing some tests with SLES installing in a SAN but I something wierd is happening. I assigne 2 LUNS in 2 differents HBAs and I see both hard disks during the installation and I do the next schema of partition: hda --hda1 (RAID type) --> 100 MB for boot --hda2 (RAID type) --> Rest of the disk for LVM ( sawp and / ) hdb --hdb1 (RAID type) --> 100 MB for boot --hdb2 (RAID type) --> Rest of the disk for LVM ( sawp and / ) The installation procedure finished ok. But when I restart I get the next message a lot of times and I can't start even in secure mode... Reading all physical volumes. This may take a while... No volume groups found No volume groups found Reading all physical volumes. This may take a while... No volume groups found No volume groups found Reading all physical volumes. This may take a while... No volume groups found No volume groups found In normals Hard Disks I can install in the same way with no problems Does anybody know something about it... Thanks in advance -- obed.org.mx -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org