Mailinglist Archive: opensuse (3622 mails)

["Andrew Joakimsen" <joakimsen@xxxxxxxxx>]

If you set vnc=1 only it then ASKS FOR THE PASSWORD.

What is the logic that if you do not define vnclassword=foo, the
software prompts for the password yet still it does not work because
vncpassword=foo was not defined?



On Sun, Jun 22, 2008 at 2:08 PM, Brian K. White <brian@xxxxxxxxx> wrote:
> ----- Original Message ----- From: "Andrew Joakimsen" <joakimsen@xxxxxxxxx>
> To: "Ciro Iriarte" <cyruspy@xxxxxxxxx>
> Cc: "opensuse" <opensuse@xxxxxxxxxxxx>
> Sent: Sunday, June 22, 2008 1:29 AM
> Subject: Re: [opensuse] VNC Remote Install on 11.0 Broken
>
>
> > I did not use any parameter except adding "vnc=1" but it did prompt
> > immediately for a password.
> >
> > There is no error on the screen until AFTER I connect, enter the
> > password, the screen shows up for 1/2 second and then goes away and
> > then the console on the local PC displays the error.
>
> You need at minimum:  vnc=1 vncpassword=something
>
> Where did you learn about vnc=1 and it didn't also show you vncpassword=foo
> ?
>
> --
> Brian K. White    brian@xxxxxxxxx    http://www.myspace.com/KEYofR
> +++++[>+++[>+++++>+++++++<<-]<-]>>+.>.+++++.+++++++.-.[>+<---]>++.
> filePro  BBx    Linux  SCO  FreeBSD    #callahans  Satriani  Filk!
>
> --
> To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
> For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx
-- 
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx