On Friday 28 December 2007 07:45:51 pm Bryen wrote:
On Fri, 2007-12-28 at 18:25 -0500, william oakes wrote:
Folks,
I have installed OpenSuse 10.3 (from a downloaded ISO and from the retail package) on two of my computers without a problem.
The third computer is giving me fits. It presently has v.10.2 loaded. When I boot from the DVD to install v.10.3 from the retail package, Yast comes up without any problems, but bombs out when it tries to load the repositories from the DVD. I have tried two separate DVD drives, the newest was a double layer drive. The double layer drive gives error message that no repositories were found. Running check media gives a message stating that the media is broke. The second DVD brings up Yast but fails to install the repositories and keeps asking to retry.
Is there some setting I can use to ensure that the repositories are found on the DVD. This is the same DVD that I used to install 10.3 on the other computers.
Any advice would be appreciated.
TIA
Regards, Bill...
I just had the same problem upgrading my home server. The solution that I found was to change the DVD reader to be the master from slave on the IDE bus by changing the jumpers. It then worked with no trouble. BoB C