Mailinglist Archive: opensuse (3202 mails)

[Jose <jtc@xxxxxxxxxxxxxxxxxxxxxxxx>]

Sucess!!

I endup disabling xgl, but then I went into the software management, and
checked what version of fglrx was active according to Suse, it was
pointning to the new driver, without uninstalling I selected the lower
version and that led to suse wanting to install the proper version of
the driver again, I went with it, and after that I opened the xlgfr gui
management interface and I selected enable compiz and enable
compiz-fusion, rebooted and now I have compiz fully functional, only
flaw I detected it's that if I raise my resolution above 1024x764 that
disabled 3d and good bye compiz with that, is this a known bug?, or is
supposed to work with any resolution allowed by the driver?

Domo arigato Rajko

Rajko M. wrote:
> On Thursday 15 November 2007 07:56:27 am Jose wrote:
>   
> > Hi Raiko,
> >
> > Tried, but same result, I get the different window decoration, rotating
> > cube as soon as I enable xgl, but it becomes slow to the bone, I am afraid.
> >     
>
> Again, /var/log/Xorg.0.log and this time also run '3Ddiag' and post output.
>
> I noticed something, that is same in your previous Xorg.0.log and in 
> http://suseforums.net/index.php?showtopic=39985
>
> (II) fglrx(0): Shutdown CMMQS
> (II) fglrx(0): [drm] removed 1 reserved context for kernel
> (II) fglrx(0): [drm] unmapping 8192 bytes of SAREA 0x2000 at 0xb7bfe000
>
> but I still can't find anything relevant. 
>
> Have you tried to compile driver as in http://en.opensuse.org/ATI ? 
>
> Have you removed old driver? 
>
> Have you tried to use 10.2 xorg.config file with 10.3? 
>
>   
-- 
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx