On Sat February 17 2007 07:58, Walter Docherty wrote:
However, when I reconnected drives 1 and 2 and booted to drive 3 (via the BIOS) Lilo ran and I was able to boot into Vista without problems. But when I try to boot into 10.2 the startup hangs after a while and the machine requires a hard reboot. <snip>
Hi Walter, Since you installed with drives 1 and 2 detached, the system has not been configured to use them once re-attached. Before shutting down to reconnect them, you must compensate for this situation by repairing the device mapping in Lilo's boot menu... also add the appropriate devices to /etc/fstab... also check/fix Lilo's equivalent to /boot/grub/device.map (sorry, I haven't configured or used Lilo in too long to remember!) hth & regards, Carl -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org