On Dec 14 2006 17:28, michael norman wrote:
On Thursday 14 December 2006 14:19, Jan Engelhardt wrote:
You can stop after make install.
Then go into Yast network card config, you should see the card there, select the card and click on edit, click on advanced and hardware details and change the name to rt2500
This is not required. Each module has a list of PCI/USB/etc. IDs it supports. In fact, if I both have rt2500 and rt2500pci in /lib/modules, udev happily loads both of them and I am to guess which one is in use.
I am not sure what you mean, but I can select either in Knetworkmanager, and in neither case will it retain the settings after I have entered the WEP key.
I was talking at a level below yast, where there is only modprobe, so I might messed that up. -`J' -- -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org