This is so minor as to be barely worth mentioning, but here it is. When I got to the part of the install where you accept (or adjust) the video, I switched on hardware 3D, bumped up the color space to the maximum, and then viewed the test (where you get to stretch and shrink the margins and move/center the picture on your display). I found that the increments for moving the picture left or right, or for re-sizing it were too large. That is, on my 19-inch Acer LCD, the test picture was a a bit off-center. If I click the arrows to move left or right, it jumps too far. If I re-size, the new size is slightly too big, or slightly too small. I can't get a combination of size and position that centers the picture, edge to edge on the monitor. In 10.1 and earlier, it worked fine (or I got lucky). Yes, I could use the monitor's own controls to fine-tune, but then I'm messing up the picture for Windows (yes, after five years without Win on my home PC, I've re-installed it in order to use particular software - FrameMaker and MadCap Flare and DreamAquarium, if you must know :-) So, shouldn't SAX have an increment-size adjuster? It does, and I missed it? Where? Can I edit a config file to make the increment smaller? As I said, not a big deal, but noticeable. Cheers, Kevin The information contained in this electronic mail transmission may be privileged and confidential, and therefore, protected from disclosure. If you have received this communication in error, please notify us immediately by replying to this message and deleting it from your computer without copying or disclosing it. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org