On Sunday 30 July 2006 03:17, Patrix Bumi wrote:
5. and finally configure the wlan0 with yast2 (network device) as follows: - I chosed "wireless" as device type - Configuration name "0" it results wlan0 - Hardware configuration name: static-0 - Module name : ndiswrapper - IRQ : I left it blank - Operating mode : managed - network name (SSID) : linksys - Encryption : Open / disabled - IP : 192.168.1.140 / 255.255.255.0 - gateway : 192.168.1.1
Whao, are you saying you MANUALLY set that IP rathern than letting the Linksys give you one? Because the output of your iwconfig says you are not talking at all to that router.
suse5:~ # iwconfig wlan0 wlan0 IEEE 802.11g ESSID:off/any Mode:Auto Frequency:2.462 GHz Access Point: Not-Associated Bit Rate:54 Mb/s Tx-Power:20 dBm Sensitivity=-121 dBm RTS thr:2347 B Fragment thr:2346 B Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Also, are you sure you even need ndswrapper for that particular nic? -- _____________________________________ John Andersen