Hello, I am connected to 2 different ISPs using a single NIC and different IPs. // routing table liviudm:~ # route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 85.x.x.0 85.x.x.1 255.255.255.0 UG 0 0 0 eth0 86.x.x.0 * 255.255.254.0 U 0 0 0 eth0 link-local * 255.255.0.0 U 0 0 0 eth0 10.0.0.0 * 255.224.0.0 U 0 0 0 eth0 loopback * 255.0.0.0 U 0 0 0 lo default 86.x.x.1 0.0.0.0 UG 0 0 0 eth0 // ifconfig output liviudm:~ # ifconfig eth0 Link encap:Ethernet HWaddr 00:40:F4:42:CE:E4 inet addr:86.x.x.45 Bcast:86.x.x.255 Mask:255.255.254.0 inet6 addr: fe80::240:f4ff:fe42:cee4/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:3497828 errors:177 dropped:0 overruns:0 frame:0 TX packets:1887956 errors:0 dropped:0 overruns:8 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1132482541 (1080.0 Mb) TX bytes:567938046 (541.6 Mb) Interrupt:11 Base address:0x2000 eth0:anet Link encap:Ethernet HWaddr 00:40:F4:42:CE:E4 inet addr:85.x.x.45 Bcast:85.x.x.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Interrupt:11 Base address:0x2000 eth0:lan Link encap:Ethernet HWaddr 00:40:F4:42:CE:E4 inet addr:10.1.5.224 Bcast:10.31.255.255 Mask:255.224.0.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Interrupt:11 Base address:0x2000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:507 errors:0 dropped:0 overruns:0 frame:0 TX packets:507 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:34687 (33.8 Kb) TX bytes:34687 (33.8 Kb) // end of config Is there any possibility to use both connections as a single line? Like eth0-speed + eth0:anet-speed = usable speed. If not is there any way to use one connection for bittorrent downloads (I'm using Azureus) and the other one for browsing (Firefox)? Best wishes, -- Damian Mihai Liviu Phone: +40741226993 Yahoo: liviudm_cisco URL: http://liviudm.blogspot.com