Hi there, I currently try to update a machine from SuSE 9.3 (minimum installation + XEN 2) to SuSE 10.0 + XEN 3. I had some virtual machines running on this system for about three month without major problems. After update to SuSE 10.0 xend crashed when starting virtual machines with the old kernel of SuSE 9.3 for the VM - not a nice behaviour but maybe acceptable for an unfinished product. Anyway - using the the current kernel of SuSE 10.0 I was able to boot such a VM. The slight problem here: I'm not able to get the network running in any of these VM's. eth0 is configured with a static IP as before but no packet is going out, no packet is received. There is no firewall active and after hours of searching the net I still have no idea how to solve this problem. Maybe someone can give me a hint. To check if this problem is related to SuSE 9.3 within the VM I tried to install a SuSE 10.0 VM with the YaST Module. Ok, I had to install yast-qt on a headless machine and forward a X11 display, I had to install xterm, which seems to be needed by this module even when there is no rpm dependency to the xterm RPM, but at the end all I get is a 1GB sized disk image and a misconfigured config file for domain1. When I add by hand the path to kernel and initrd file and start the VM, I end with a console log which tells about a timeout when connecting to hda or stopping short before telling about this. The last lines in xm console are the following: RAMDISK driver initialized: 16 RAM disks of 64000K size 1024 blocksize loop: loaded (max 8 devices) Xen virtual console successfully installed as tty1 Event-channel device installed. Neither TPM-BE Domain nor INIT domain! xen_blk: Initialising virtual block device driver Registering block device major 3 hda: I'm sure I'm missing something easy but it would be nice if someone could tell me what it is. Regards Ralf