B. Stia schreef:
On Monday 22 August 2005 06:41 am, Koenraad Lelong wrote:
ken schreef:
Koenraad Lelong wrote:
... ... They are recognized by the BIOS, in the BIOS-setup there is a screen : hardware monitoring. That displays three different tempratures and the speed of three fans. Also a number of voltages are monitored. Are dmesg or hwinfo capable of handling I2C devices ? The whole purpose of "lm-sensors" is to provide drivers for applications. sensors-detect tries to detect what drivers (kernel-modules) are needed. Then you have to make those drivers available at boot and start the "sensors" application. Well, the drivers are available (lsmod shows them) but the "sensors" application complains about "no sensors". --
Has there been any resolution to this. Had been following this thread until it's abrupt stop. Have the exact same problem but the mo-bo is a MSI K8T (939AMD)
Bob
Well, friday I installed 9.3 on the board with a spare disk, there the sensors work fine. I'm going to upgrade (actually a fresh install) to 9.3 on the "real" disk. I tried to compile a new LM85 module for the Suse 9.2-kernel using a patch I found, but this seemed not to work. -- Met vriendelijke groeten, Koenraad Lelong R&D Manager ACE electronics n.v.