Hi All, I have just bought a Linksys WPM54G for my existing SuSE 9.2 installation. When I installed the card and switched on the PC for the first time suseplugger recognised the card and asked if I would like to configure it, which of course I tried, but it wasn't in the list of available cards. So after many hours of searching Google and trying the options that I found, I finally sort of got it working. Here is what I did :- 1. Use Synaptic to get ndiswrapper-tools 2. Get the windows drivers, and copy the .sys and .inf to somewhere (say /home/<yourusername>/Linksys/) 3. Open terminal, and enter the following commands: 3a. cd Linksys 3b. sudo ndiswrapper -i <name>.inf (mine was rt2500.inf) 3c. cd /etc/ndiswrapper/ 3d. sudo modprobe ndiswrapper 3e. sudo echo ndiswrapper >> /etc/modules 3f. sudo iwlist wlan0 scan (look for your access point in the list) 3g. sudo iwconfig wlan0 channel <X> essid <ESSID> mode Managed (the X and ESSID should come from the iwlist) 3h. sudo ifup wlan0 The above was found on :- http://ubuntuforums.org/showthread.php?t=5645 This seemed to work, sort of. When I rebooted, the card was not loaded automatically, so I used the following to enable the card :- ifconfig wlan0 up iwconfig wlan0 channel X essid X mode Managed dhcpcd wlan0& (This command gave me an error, sorry can't remember what it was, but it seems to work) My question is 2 fold. 1. Is there an easier way to do this as I have another couple of SuSE 9.2 boxes to install the wireless cards into. 2. How do I set it up so that I don't have to manually type the above 3 commands and that the wlan0 card is loaded at boot time. Thanks in advance for your help. I hope the above is clear, but I've been trying to get this working for about 18 hours now. Martin