On Tuesday, March 1, 2005 09:51 pm, Richard wrote:
I'm running Su'SE 9.2 with a D-Link dwg-650 pcmcia wireless. It configures fine with Yast. When I get it going it goes out to a D-Link WiFi router Model DI-624 and gets an IP faithfully. I can ping the router and run the router utility from my laptop, yet I cannot get anything through the router until I power it down and repower it. Then all works fine.
By cannot get anything through, I mean I cannot ping the internet connection or anything on the internet. The error message says no connection. If I run a cable to the router, I can get an ip and go onto the net without fail.
Running windows I can get the ip and go onto the net without having to unplug the router.
It appears the wireless router firewall is set up to allow all on the lan to go to the net. Any ideas?
The DI-624 series are not the most reliable unless you change a few things, in our experience. What we have found necessary is to: 1. Upgrade to the latest firmware, but be careful because the firmware is version-specific and there are three versions (A, B, and C). 2. Turn off Turbo mode and WPA. Even so, they still seem to require power-off rebooting every few weeks and they don't like getting hot. We have one A model we maintain however that we run at 802.11b with WEP and no DHCP, and that works flawlessly; stays up for months and months and services three simultaneous wireless connections with no packet errors, even though all the wireless connections (at least at the client end) report less than 50% signal strength. YMMV! Mark -- _________________________________________________________ A Message From... L. Mark Stone Reliable Networks of Maine, LLC "We manage your network so you can manage your business." 477 Congress Street Portland, ME 04101 Tel: (207) 772-5678 Web: http://www.rnome.com