I am trying to install SLES 9 on a system with 2 36gb SCSI disks with a RAID 1 config. First I create 6 partitions as follows: On sda and sdb I create 3 partitions each as follows: Primary partition, Type 0X83, no mount point, size 100mb (for /boot) Primary partition, Type 0x83, no mount point, size 1024mb (for swap) Primary partition, Type 0x83, no mount point, size 33gb (for /) I then select Raid->create and create 3 RAID 1 devices: md0: /boot using sda1 and sdb1 (formated as ext3) md1: swap using sda2 and sdb2 (formatted as swap) md2: / using sda3 and sdb3 (formatted as ext3) Everything seems to go fine and I install the entire OS and get to the end of the install when it is performing the final configuration changes. It then fails saying unable to install LILO. I then retry and select grub (new configuration) and same thing. If I reboot the system I end up at a grub prompt. The same partitioning scheme worked on Fedora Core 2 which was what this install was replacing. Any ideas what my problem is? Thanks, CC ===== Chuck Carson - Sr. Systems Engineer Syrrx, Inc. - www.syrrx.com 10410 Science Center Drive San Diego, CA 92121 Work: 858.622.8528 Fax: 858.550.0526