This is going to sound silly, but I would try enabling power management. I have the ipw2200 in my system, and sometimes it won't work unless I have
Strange... Well, if I were you guys, and I really wanted it up and running, I would download the ndiswrapper and use that module then. I had to set that up when I was using 9.1 because the ipw2200 was not supported out of the box. http://ndiswrapper.sourceforge.net/ is the website, and there is pretty straight-forward documentation. The install is relatively quick, you don't need to recompile the kernel. Rather, you just compile the module for the kernel you are already using. Testing this will also help pin down what the problem is. If ndiswrapper works, then it's most likely the ipw2100 module. If ndiswrapper does not work, then it's most likely a setup issue. Mike Sacco -----Original Message----- From: boricua Orman [mailto:boricua@pepino.is-a-geek.org] Sent: Tuesday, November 23, 2004 7:14 PM To: Michael Sacco Cc: suse Subject: RE: [SLE] wireless card ipw2100 On Tue, 2004-11-23 at 00:29 -0500, Michael Sacco wrote: the
power management on. It can be turned on by using the following command:
iwconfig eth1 power on
A quick type of "iwconfig eth1" afterwards should show that the command took
stays on for a second and back to off -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com