Thank you both for your help. I already have been able to put my wireless
card to work. What I've done was to clean my resolv.conf file and out my
wireless card to get ip by dhcp and everything started to work, strange
because when I had suse 9.0 I was not able to put it working with dhcp but
always with static ip.
Cumprimentos
Jose Silva
-----Original Message-----
From: jim jacobs [mailto:jim.jacobs@mindspring.com]
Sent: sábado, 19 de Junho de 2004 23:39
To: Blue Moose IT Support; suse-linux-e@suse.com
Cc: Jose Silva
Subject: Re: [SLE] Suse 9.1 Wireless Card
Your /etc/sysysconfiig/network/ifcfg-wlan-pcmcia file must contain the
following lines:
BOOTPROTO='dhcp'
DHCLIENT_SET_DOWN_LINK='yes'
MTU=''
REMOTE_IPADDR=''
STARTMODE='hotplug'
DHCLIENT_MODIFY_RESOLV_CONF='yes'
DHCLIENT_SET_DEFAULT_ROUTE='yes'
UNIQUE=''
WIRELESS_ESSID='yourESSID'
WIRELESS_KEY='yourKey'
WIRELESS_MODE='Managed'
WIRELESS_NICK=''
WIRELESS_NWID=''
The two lines with DHCLIENT are particularly important. If you can find
where this is documented, please let me know.
Good luck,
-----Original Message-----
From: Blue Moose IT Support
Hi.
I'm having some trouble using my orinoco wifi card in suse 9.1. Everything is set up in yast, wep key, essid, static ip, gateway and dns. I can ping my other 2 pc (192.168.1.45 and 192.168.1.50) but i cannot ping my gateway (192.168.1.1) or access internet. When i use my other network card configured with dhcp everything works fine. My kernel routing table when i use this network card is the following
Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 0 0 0 eth0 link-local * 255.255.0.0 U 0 0 0 eth0 loopback * 255.0.0.0 U 0 0 0 lo default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
Can anyone tell me why this is happening
Cumprimentos
Jose Silva
-- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com