Did you notice that there was an upgrade of that part of YAST last night !!! ;-) Johan Torsdag 20 maj 2004 06:31 skrev Sid Boyce:
Mike wrote:
I just updated a solid 9.0 setup to 9.1 and am having a very odd problem. When I boot the system, I get the following errors in the boot log:
Setting up network interfaces: lo lo IP address: 127.0.0.1/8 doneWaiting for mandatory devices: bus-pci-0000:02:01.0 eth-id-00:0c:f1:6d:25:31 20 19 18 17 16 14 12 11 10 9 8 7 6 5 4 3 2 1 0 bus-pci-0000:02:01.0 No interface found failed eth-id-00:0c:f1:6d:25:31 No interface found failedSetting up service network . . . . . . . . . . . . . . . .failed <notice>exit status of (network) is (7)
If I go to YAST, the network device is all nicely setup. All I have to do is click Finish and everything works fine...until the next reboot when the process starts all over.
The system is a vanilla Intel motherboard with a single builtin ethernet adapter (which makes the bus-pci and eth-id entries kind of odd).
Any ideas?
Thanks, mike.
Before going into YaST, check if the ethernet module is loaded. If not loaded try "rcnetwork restart". The bus-pci etc. entries are OK, see /etc/sysconfig/network/ifcfg-eth-id-00:0c:f1:6d:25:31, the 20-0 is the 20 second timeout value countdown for the interface to become active.
Regards Sid.
-- Sid Boyce .... Hamradio G3VBV and keen Flyer Linux Only Shop.