Mailinglist Archive: opensuse (4547 mails)

["Carlos E. R." <robin1.listas@xxxxxxxxxx>]

The Friday 2004-04-30 at 16:40 +0200, Luca Mollica wrote:

> winconfig, I have tried to connect to my ISP, but I had bad response, that
> was
>
> NO ANSWER
>
> I had the accuracy to use X3 parameter, that could be right for skipping
> dialtone waiting (in Italy there is no long and continous dialtone before
> dialing the number).


I'm not sure if that is the purpose of X3. "ATX3" command just configures
some response strings of the modem - but I could be wrong.

You have to set register 6 (on my US robotic modem, check your manual) to
0 (cero):

S-Registers

To change a setting, use the ATSr=n command, where r is the
register and n is a decimal value from 0 - 255 (unless otherwise
indicated).

 Register Default Function
--------------------------
   S6        2    Sets the number of seconds the modem waits
                  before dialling. If Xn is set to X2 or X4,
            this is the time-out length if there isn't a dial tone.


However...

> --> Idle Seconds = 30, disabling automatic reconnect.
> --> Sending: ATDT7020001099
> --> Waiting for carrier.
> ATDT7020001099
> NO ANSWER

Your modem does dial, but there is no answer from the destination number,
check that number.

-- 
Cheers,
       Carlos Robinson