* Bill Wisse
On Tuesday 01 July 2003 11:39, Patrick Shanahan wrote:
[snip ...]
From a clean boot w/o the card-reader present. Plug-in the card-reader and wait. Approx 5 seconds you should hear a beep indicating hotplug has recognized (iianm) the device and a line should automatically appear after an empty line at the bottom of /etc/fstab, ie: /dev/sdb1 /media/sdb1 auto noauto,user,exec 0 0 #HOTPLUG B3Fu.4G0qp7e_XDE
I did that but ..no line here is the output:
/dev/hda3 / reiserfs defaults 1 2 /dev/hda1 /boot ext2 defaults 1 2 /dev/cdrecorder /media/cdrecorder auto ro,noauto,user,exec 0 0 /dev/cdrom /media/cdrom auto ro,noauto,user,exec 0 0
devpts /dev/pts devpts defaults 0 0 /dev/fd0 /media/floppy auto ro,noauto,user,exec 0 0 proc /proc proc defaults 0 0 usbdevfs /proc/bus/usb usbdevfs noauto 0 0 /dev/hda2 swap swap pri=42 0 0
OK, unplug the card-reader and as root, rchotplug restart Wait a couple of minutes, plug-in the card-reader. After beep, cat /etc/fstab and look for the added line. Finally, if no positive results, cat /proc/scsi/scsi and provide the results here. Mine: pat@wahoo:~> cat /proc/scsi/scsi Attached devices: Host: scsi0 Channel: 00 Id: 06 Lun: 00 Vendor: HP Model: C2520A Rev: 3503 Type: Processor ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 00 Lun: 00 Vendor: PLEXTOR Model: CD-R PX-320A Rev: 1.01 Type: CD-ROM ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 01 Lun: 00 Vendor: HP Model: CD-Writer+ 9100 Rev: 1.0a Type: CD-ROM ANSI SCSI revision: 02 Host: scsi2 Channel: 00 Id: 00 Lun: 00 Vendor: IOMEGA Model: ZIP 250 Rev: 61.T Type: Direct-Access ANSI SCSI revision: 02 Host: scsi3 Channel: 00 Id: 00 Lun: 00 Vendor: SIIG Model: CompactFlash Car Rev: 0113 Type: Direct-Access ANSI SCSI revision: 02 -- Patrick Shanahan Registered Linux User #207535 http://wahoo.no-ip.org @ http://counter.li.org