Mailinglist Archive: opensuse (4749 mails)

["L. Mark Stone" <LMStone@xxxxxxxxxxx>]

I just did a clean install of 8.2. When the system boots and attempts to
load the log in screen, my monitor displays a warning that the signal is out
of sync.

I booted "Failsafe", and tried running yast in text mode. It shows that my
monitor was detected as a Samsung SyncMaster 4S, when in fact it's a Samsung
SyncMaster 957MB. When I try to change the settings using yast, I get the
same blank screen with the monitor displaying the "out of sync" message
again.

I get the same result when I try to run sax2 directly. Once sax2 launches,
the screen goes blank with the out of sync message.

Since I can get to a command line, and I (think I) can use vim, what is the
X config file I need to edit manually?

Thanks,
Mark
_____________________________________________
A Message From...  L. Mark Stone

Reliable Networks of Maine, LLC
477 Congress Street, 5th Floor
Portland, ME 04107
Tel: (207) 772-5678
Cell: (917) 597-2057
Email: LMStone@xxxxxxxxx
Private: LMStone@xxxxxxxxxxx
Web: http://www.rnome.com