Hi, I have Adaptec SCSI Raid Controller 2100S with SuSE 8.2 installed and I did not have problems, not even with the software from the CD. Roger -----Ursprüngliche Nachricht----- Von: Ivan Gustin [mailto:ivan@elin.hr] Gesendet: Freitag, 2. Mai 2003 23:54 An: SuSE mailing list Betreff: [SLE] Adaptec SCSI RAID 2120S Hi, I have Adaptec SCSI RAID controller 2120S with 2 x Seagate 36 GB Ultra320 on Intel S845WD1H Woodruff motherboard with 2.4 GHz P4 and 512 MB ECC RAM. I want these disks in RAID 1 (mirror) and to be bootable. I can't install SuSE 8.1 Pro because install routine doesn't recognize RAID controller, so it cannot see SCSI disks. I tried to load aacraid module, but I only got a message: aacraid.o: init_module - No such device. I tried with many parameters (io, irq...) without succes. Adaptec says on many places that he support SuSE Linux with proper driver (on CD, on Web...). There is a note about something that SuSE Linux cannot boot from Adaptec RAID disks, but it can be solved (first to remove SCSI driver). I tried to install SuSE Linux 8.1 Pro on IDE disk and then try to install RAID driver, but no success. How can I load aacraid module on the proper way? Is there some parameters needed to be specified? I know all parameters about controller (io, slot, pci, irq...), because Yast2 can find it and shows all informations. Can SuSE Linux 8.1 boot from RAID disks? Is there better Adaptec RAID support in SuSE 8.2? Thanks for suggestions from anyone who uses this controller. -- Ivan Guštin -- Ovaj mail provjeren je antivirusnim programom ESET NOD32 prilikom prolaska kroz mail server. This mail has been scanned by antivirus software ESET NOD32 during passing through mail server. -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com