Mailinglist Archive: opensuse (4288 mails)
| < Previous | Next > |
Re: [SLE] nothing after eth0 with more than 1 network card
- From: Fábio Rabelo <fabior@xxxxxxxxxxxx>
- Date: Wed, 08 May 2002 13:16:47 -0300
- Message-id: <3CD94F6F.B019543D@xxxxxxxxxxxx>
Hi. Our server needs 2 ethernet cards, on internet and one local. I can get
> either the local lan or the internet by swapping cables but not both at the
> same time. Swapping the cards still only gives me eth0 active. Yast (version
> with 8.0) identifies both no problem and the little green lights are on.
> Adding a third and fourth card results in the same problem. Any ideas anyone?
> Is there anyting in Bios I should know about? This is a new machine with a
> new install of 8.0.
> Thanks, Steve.
What network card model ?
If it is ISA card, you must configure I/O and IRQ BEFORE configuration, run
the config program for the card and set up one I/O and one IRQ diferent to
each one !
If is PCI card can be bios, put them in "auto" in plug'play section abd try again
.
Fábio Rabelo
> either the local lan or the internet by swapping cables but not both at the
> same time. Swapping the cards still only gives me eth0 active. Yast (version
> with 8.0) identifies both no problem and the little green lights are on.
> Adding a third and fourth card results in the same problem. Any ideas anyone?
> Is there anyting in Bios I should know about? This is a new machine with a
> new install of 8.0.
> Thanks, Steve.
What network card model ?
If it is ISA card, you must configure I/O and IRQ BEFORE configuration, run
the config program for the card and set up one I/O and one IRQ diferent to
each one !
If is PCI card can be bios, put them in "auto" in plug'play section abd try again
.
Fábio Rabelo
| < Previous | Next > |