On Monday 03 September 2001 20.14, Bruce Marshall wrote:
On Monday 03 September 2001 03:06 pm, Martin Webster wrote:
On Monday 03 September 2001 3:50 pm, Chris Herrnberger wrote:
On September 2, 2001 09:27 am, Martin Webster wrote:
Did you type insmod aha1542=0x330?
Thanks for responding this is driving me nuts. Are you sure the syntax is correct. I understand what you are doing but Im not sure that this is the correct manner to enter the parameter:
Yes, I should have said insmod aha1542 aha1542=0x330. There are some optional parameters but I'd try this first. If this works you can add boot support later.
M
My 'somewhat authoritative' book says there "are no module parameters" for aha1542, only boot parameters.... Strange if it is true but that what it says.
The source says differently: (from /usr/src/linux/drivers/scsi/aha1542.c) * LILO/Module params: aha1542=<PORTBASE>[,<BUSON>,<BUSOFF>[,<DMASPEED>]] ^^^^^^^^^^^^^ * * Where: <PORTBASE> is any of the valid AHA addresses: * 0x130, 0x134, 0x230, 0x234, 0x330, 0x334 * <BUSON> is the time (in microsecs) that AHA spends on the AT-bus * when transferring data. 1542A power-on default is 11us, * valid values are in range: 2..15 (decimal) * <BUSOFF> is the time that AHA spends OFF THE BUS after while * it is transferring data (not to monopolize the bus). * Power-on default is 4us, valid range: 1..64 microseconds. * <DMASPEED> Default is jumper selected (1542A: on the J1), * but experimenter can alter it with this. * Valid values: 5, 6, 7, 8, 10 (MB/s) * Factory default is 5 MB/s. */ #if defined(MODULE) int isapnp = 0; int aha1542[] = {0x330, 11, 4, -1}; MODULE_PARM(aha1542, "1-4i"); MODULE_PARM(isapnp, "i"); regards Anders