HELP, I've almost got it going, but I'm missing something. I've had this thing for almost 4 months gathering dust with several failed attempts at getting it running. As I've said I almost had it working but I lost the use of my usb keyboard (Macally IKEY). Here below is what I've done so far - but what's missing? xf86config includes the following lines:- "Section "Module" Load "xf86GraphireUSB_3.so" EndSection Section "XInput" Subsection "gmouse" Port "/dev/input/event0" DeviceName "Graphire Mouse" Mode Relative AlwaysCore EndSubsection Subsection "gstylus" Port "/dev/input/event0" DeviceName "Graphire Pen" Mode Absolute AlwaysCore EndSubsection Subsection "geraser" Port "/dev/input/event0" DeviceName "Graphire Eraser" Mode Absolute AlwaysCore EndSubsection EndSection" This is the contents of /etc/config.d/usb.rc.config # # Configuration file for USB support # # # USB_HCI sets which USB controllers are present. Set this to # "usb-uhci" (Intel/Via chipsets), "usb-ohci" (other chipsets) or # "usb-ohci_hcd". You may specify more than one. "auto" (or leaving it # empty) will result in the script examining your PCI config space and load # the driver it thinks is the correct one (or none). # USB_HCI="usb-uhci usb-ohci usb-uhci_hcd" # # USB_DRIVERS specifies which drivers should be loaded on USB startup. # Default is "usb-keyboard mouse". You may additionally specify # acm, usb-serial, ezusb, usb-scsi, printer, hp_scanner, cpia, audio # Please note that not all of those are ready for prime time, yet. # USB_DRIVERS="hid keybdev input usb-serial evdev wacom" This is a list of /proc/bus/usb drivers loaded wacom serial hid hub usbdevfs I also, as root, did the following command "mknod event0 c 13 64" So as far as I can tell I've done everything by the book and the closest I've come is the mouse and pen worked after booting up but as the keyboard was not working I could not log in AAAaaaarrrRRGGGGggghhhHHHH!!!!! ANY HELP WOULD BE MOST WELCOME!!! Yours hopfully, Barrie Grieve.